Inventor – Weld Gap nominal parameter
I’d like to see a way to get the Frame Generator tools to access the parameters. I am a top down kind of guy, and like using extrusions and dependent sketches for my frame skeletons. I derive almost everything to keep all my parameters centrally located.
The design I am currently engaged in was started without some specs, and after receiving them I find that he builder does not want any weld gapping. So I have to run through every weld and remove the gaps.
It would be nice to set the gaps a local parameter that is factored from a derived parameter, like ‘NomWeldGap = MatThickness * NomWeldGapFactorl’ or something similar. This way I can change the NomWeldGapFactor in the skeleton, and all the gap would alter in relation to their individual material thicknesses.
-
Archives
- March 2010 (2)
- February 2010 (5)
- January 2010 (5)
- December 2009 (3)
- November 2009 (5)
- October 2009 (8)
- September 2009 (11)
- August 2009 (5)
- July 2009 (4)
- June 2009 (4)
- May 2009 (4)
- April 2009 (7)
-
Categories
-
RSS
Entries RSS
Comments RSS