from Civil to Inventor

The Autodesk enthusiast exile

Civil 3D – Part Builder Part 2

Today we continue from where we left off in Part Builder Part 1.

Before we proceed, I’d like to note that a wing wall may not be everyone’s biggest desire.  I needed it, and I felt that it would proved a fairly well rounded view of things. It needs equations, and gets worked laterally instead of vertically, which make it more of a challenge.

Sitting on the axis of 2 different careers I can see this type of workflow from 2 different perspectives, and want to provide everyone with a bit more information that may have been unavailable.

  • The 3D modelers understand the construction methods.  What they need to understand is the limitations stopping them from working naturally through this process.
  • The Civil 3D techs know about odd application limitations, but need to understand how the construction methods, dependencies, and calculations work.

If you don’t get something out of this session, it will be because you already had a good working knowledge of Part Builder, or you failed to post your questions here.

The 3d Model (which is what you came for, right?) is created using the following procedures:

Create a Work Plane, Create Geometry, Add Dimensions, Add Constraints, Create Profile, Modify Dimensions, Create Modifier, and Configure Parameters.  We will discuss the first six today.

Open the part for the last session, named Wingwall Sloped.

image

Create a Work Plane

Let’s begin by creating the Top Work Plane.  I always like to get my Top plane in first.  Either I am working on it, or visually referencing it.

Under Modeling, Right Click the Work Planes folder and select ‘Add Work Plane…’

image

Continue reading

Advertisements

November 25, 2008 Posted by | Part Builder, Pipes | , , , , , , , , , , | 7 Comments