from Civil to Inventor

The Autodesk enthusiast exile

Inventor – Horizontal and Vertical Constraints


We all know about constraints.  It make the world go round. 

I have a reasonable amount of twisted workarounds, but very little every day constructive examples.  So, I as thinking of AU (as ALWAYS) and was reminded of Dan Banach drilling productivity tips at us, and Horizontal and Vertical constraints were mentioned numerous times (seriously, take his class at AU).

Whether you are in training or didn’t pay attention to this feature, you should consider it.

This Horizontal constraint should be applied to geometry that passes through the horizontal plane from another reference feature. Refer to the image below.  I’d like the sketched geometry to be evenly distributed across this part.  The best way is with constraints.


Continue reading

November 21, 2008 Posted by | 2009 | , , , | Leave a comment