from Civil to Inventor

The Autodesk enthusiast exile

Tiered Grading in a hurry

Recently in one of the Civil 3D discussions, a poster requested a fast solution to a multi tiered grading. The requirements were 2 tiers@ 1:1 cut slope, each 4.5m deep, with a flat 1m land in between, and it appeared flat at the bottom. The fill slope was similar, but @2:1 slope. 

In an attempt to VERY quickly help the poster, I use feet in this ugly example, but the process is the same. Continue reading

October 20, 2008 Posted by | AutoCAD Civil 3D, Gradings | , , , , , | 1 Comment